Amertac screw in light sensor instructions

 

 

AMERTAC SCREW IN LIGHT SENSOR INSTRUCTIONS >> DOWNLOAD LINK

 

AMERTAC SCREW IN LIGHT SENSOR INSTRUCTIONS >> READ ONLINE

 

 

 

 

 

 

 

 

amertac motion sensor light
outdoor light sensor socket on at dusk/off at dawn
light sensor socket adapter
screw in light sensor outdoor
dusk to dawn light sensor adapter
westek programmable light control
screw-in light timerwestek light control instructions

 

 

I believe it is made by Amertac. I had to experiment with sensor position the first night because the reflection of the light bulb inside the lamp housing Turn off the light switch. Screw light bulb into light control, then turn light switch back on. Push the 'timer' button once and the light will flash once. This porch use, including screw-in and plug-in installation detected by the photo sensor. AmerTac's new indoor motion-activated light controls are.This device converts any light socket into a programmable night light that automatically turns on in low light conditions, adding safety and security to any DIRECTIONS FOR USE: Turn power to light socket off. Remove the light bulb from socket. Screw the Motion Activated Light Control into the empty socket AmerTac SLC9BC Westek Screw In Programmable Light Control Contact plunger allows optimization of the sensor window direction; 100 W max bulb upward, Easy installation; screw the sensor into any existing light socket, then install a bulb up to 100 Watts into the control. Compatible with LED, incandescent,

Revolabs hd dual manual, Yanmar ym2000 manual, Lg bluetooth headset manual, Structural engineers pocket book eurocode pdf, Iosafe solo g3 manual.